Up and Coming products;

[Dbl G]

This is the place to preview items before they hit the market..

[Dbl G]

We also carry 70-80-90-100mm Idlers Pulleys..

http://i66.photobucket.com/albums/h254/DblG/Pulleys/P1110430.jpg

http://i66.photobucket.com/albums/h254/DblG/Pulleys/P1110434.jpg

http://i66.photobucket.com/albums/h254/DblG/Pulleys/P1110436-1.jpg

[Run2Speed]

looks good :bigtu:

[Dbl G]

If you have replaced any bearings in your Idlers these may well fix that problem. After working on many a truck in the past and noticing wobbly pulley's we decided to come up with a fix. These shoulder supports snug into the bearing race and extend the stock or aftermarket bearing post eliminating there short coming.
They come in from the outside and give the extra support the manufacture of the other goods didn't mic out to makes sure they were long enough.
Simply check yours before ordering because if yours are long enough these can and will create another problem if your studs are correct in length.
You can remove the screw from the Idler center and either feel with you finger tip or visually inspect them to determine wither or not the studs are short.
Only for use on short bearing stud supports.
Both the Support and the Bolts are 304 Stainless Steel.
$8 per w/o SS screw
$10 per w SS screw
Free shipping of course.

http://i66.photobucket.com/albums/h254/DblG/New%20Projects/P1110443.jpg

[Dbl G]

These are selling quick guy's,, the other sites are eating them up...

[Dbl G]

ttt

[Rob_03Cobra]

http://i66.photobucket.com/albums/h254/DblG/Pulleys/P1110436-1.jpg

niiiiiiiiiiiiiiiiiiice :bigtu:
THEY LOOK JUST PLAIN OLE BAD ASS :cheers:

Hell if I had Kales money, I'd buy them and let the kid use them as building Blocks, OR SOMETHING.....

[Run2Speed]

Hell if I had Kale's money I would too